The link between M. chimaera and heater cooler units grows stronger

A new paper in the Journal of Hospital Infection from Germany confirms the work of Hugo Sax and colleagues in Switzerland on the aerosolization of M. chimaera by heater cooler units. These investigators cultured M. chimaera from the water tanks of 4 Sorin heater cooler units, and were able to culture the organism from the air in the operating room only when the units were turned on. They were also able to culture non-fermenters from the air up to 10 feet from the heater cooler units when the units were turned on, but not when they were turned off. Importantly, the investigators were not able to culture M. chimaera from the hospital's water supply. And the authors note that whole genome sequencing of clinical and environmental isolates from the Netherlands and Germany suggests the possibility that the heater cooler units are intrinsically contaminated (i.e., this is a point source outbreak).

Lastly, the authors state that "only strict separation of the heater cooler unit from the operating room appears to enhance patient safety." We agree and that is the mitigation strategy that we have used at the University of Iowa. Below are photographs of our engineers' solution, a 6 x 6 inch Corian portal through the wall of the operating room, so that the heater cooler units are housed outside of the OR. The door is light weight and closes fully when the heater cooler device is not needed, and partially when the heater cooler hoses are extending through the wall. Positive pressure in the OR is maintained when the portal is in use.

Dan and I have spoken with a number of physicians from across the country, and we are now aware of 18 M. chimaera infections in patients who have undergone cardiopulmonary bypass. All of these patients, with the possible exception of 1 patient, had a prosthetic valve or vascular implant placed. So patients with implants are most important if a look back needs to be performed for case finding.

Comments

  1. For the relocation of this equipment the manufacturer has a 5 meter (16.4 feet) Quote from the Manufacture's instructions for use (IFU): "To minimize noise exposure and avoid disturbing the air flow in the operating room, the system can be operated in an adjoining room provided that the technical construction allows for this setup. In this case, the system can be controlled via the HLM system panel. The length of the tubing between
    the heater-cooler and heat exchangers and the heating blanket must not exceed 5 m (16.4 ft).". what are users out there doing if in order to relocate outside the OR you will have to extend the tubing connection outside the recommended distance of the 16.4 feet (5m).? Non compliant with IFU's ? thanks
    Carmen

    ReplyDelete
  2. We were able to maintain the tubing at <5m after moving the heater cooler unit outside the OR.

    ReplyDelete
  3. Thanks for the visual! Is the perfusionist or RN circulator leaving the OR to operate the machine? Concerned about patient safety with personnel leaving the room, wondering how it's working out in practice.

    ReplyDelete
  4. We have a person stationed at the heater cooler unit. However, there is a remote available so that the perfusionist inside the OR can control the unit outside the OR.

    ReplyDelete
  5. How many other hospitals have done what you have done it Iowa? Phil Lederer

    ReplyDelete
    Replies
    1. I don't know. We have had several hospitals call us to discuss this.

      Delete

Post a Comment

Thanks for submitting your comment to the Controversies blog. To reduce spam, all comments will be reviewed by the blog moderator prior to publishing. However, all legitimate comments will be published, whether they agree with or oppose the content of the post.

Most Read Posts (Last 30 Days)